Federation Commander

ingkent

Based off the line drawings from the Klingon Master Starship book

[img]

[/img]

djdood · Posted: Fri Sep 16, 2016 4:00 pm Post subject:

Love it and, as-always, top-notch kitbash and fabrication work with a fantastic paint job.

I like the detailing you put on the side of the carrier deckhouse. I'm always impressed by how consistent you are with these fighter minis you scratchbuild.
_________________

ingkent · Posted: Fri Sep 16, 2016 4:56 pm Post subject:

Thanks Will. I'm constantly amazed that you can find the small details I put into these kitbashes. It's photoetched parts, usually from ship kits but this one was just cut to shape. Wanted something more than just a blank smooth side to the hanger decks. For the fighters there's actually a tiny rail under each wing drone, they're not just lying flat on the wing.

Steve Cole · Site Admin Joined: 11 Oct 2006 Posts: 3821

Well done
_________________
The Guy Who Designed Fed Commander

djdood · Posted: Sat Sep 17, 2016 11:15 pm Post subject:

Nice trick with the photoetch, Kent.

I did something similar to add some spice to the wings on my Starline2400 FD7 kitbash.

_________________

ingkent · Posted: Sat Sep 17, 2016 11:45 pm Post subject:

Nice. Looks like you did some with greenstuff too.

djdood · Posted: Sun Sep 18, 2016 12:38 am Post subject:

Much greenstuff was had. I wanted to sweep the engine struts back, for that "go fast" look.

_________________

ingkent · Posted: Sun Sep 18, 2016 1:13 am Post subject:

Very nice. Greenstuff work looks very good.