Federation Commander Forum Index Federation Commander
A NEW fast paced board game of starship combat!
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Zocchi Tug question

 
Post new topic   Reply to topic    Federation Commander Forum Index -> Miniatures
View previous topic :: View next topic  
Author Message
justicar
Lieutenant JG


Joined: 06 Feb 2008
Posts: 37
Location: Las Vegas

PostPosted: Fri Mar 07, 2008 12:10 am    Post subject: Zocchi Tug question Reply with quote

Does the Zocchi Fed Tug have any weapon mounts? I don't mean for game stats, I mean the mini itself. Thanks.
_________________
The previous page has been superseded by the following page:

This page intentionally left blank.
Back to top
View user's profile Send private message
djdood
Commodore


Joined: 01 Feb 2007
Posts: 3412
Location: Seattle, WA

PostPosted: Fri Mar 07, 2008 12:27 am    Post subject: Reply with quote

The tug has two phaser bumps on the forward lower face of the saucer "bump" and one bump on each rear quarter of the upper saucer.

The cargo pods have no weapons molded-in.
_________________
Back to top
View user's profile Send private message Send e-mail Visit poster's website
justicar
Lieutenant JG


Joined: 06 Feb 2008
Posts: 37
Location: Las Vegas

PostPosted: Fri Mar 07, 2008 3:59 am    Post subject: Reply with quote

Drat. To be expected, but drat nonetheless. Thanks.
_________________
The previous page has been superseded by the following page:

This page intentionally left blank.
Back to top
View user's profile Send private message
OGOPTIMUS
Captain


Joined: 10 Nov 2006
Posts: 980

PostPosted: Mon Mar 10, 2008 6:06 am    Post subject: Reply with quote

If you're worried about removing them, it's really not a big deal.

And if you're looking to add, well...epoxy is a simple solution.
_________________
O.G. OPTIMUS


Newest Page | Newer Page | OLD Page
Back to top
View user's profile Send private message Visit poster's website
justicar
Lieutenant JG


Joined: 06 Feb 2008
Posts: 37
Location: Las Vegas

PostPosted: Tue Mar 11, 2008 4:01 pm    Post subject: Reply with quote

Ah, but one would 1) have to have epoxy and 2) be capable of basic modeling...
_________________
The previous page has been superseded by the following page:

This page intentionally left blank.
Back to top
View user's profile Send private message
djdood
Commodore


Joined: 01 Feb 2007
Posts: 3412
Location: Seattle, WA

PostPosted: Tue Mar 11, 2008 6:06 pm    Post subject: Reply with quote

2-part epoxy glue: any hardware store or general goods store (Wall-Mart, etc.)
Toothpicks to apply epoxy dots: I'd bet you have these already.

Modeling skill: mix epoxy per directions in paper cup, dip end of toothpick in glue, touch toothpick to mini to leave a little dot of glue, allow to cure (upside down is best, so the glue doesn't flatten out from gravity).

Superglue gel can also be used, it just flows a bit more than epoxy.

That's all there is to it.
_________________
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Scoutdad
Commodore


Joined: 09 Oct 2006
Posts: 4754
Location: Middle Tennessee

PostPosted: Tue Mar 11, 2008 7:07 pm    Post subject: Reply with quote

Or, even easier if you're only adding phaser mounts:
Super glue gel...
Apply to a scrap of plastic...
Use a sharp toothpick to apply phaser bumps where desired...
1 quick shot of "Zip-Kicker" (or equivalent type super glue accelerator)...
and phasers are done!
_________________
Commander, Battlegroup Murfreesboro
Department Head, ACTASF
Back to top
View user's profile Send private message Send e-mail Yahoo Messenger
justicar
Lieutenant JG


Joined: 06 Feb 2008
Posts: 37
Location: Las Vegas

PostPosted: Tue Mar 11, 2008 7:23 pm    Post subject: Reply with quote

Next time I'll remember to put in the smileys. I can paint and model and have plenty of supplies on hand. I was really just having to kitbash, which I don't normally do unless it's for something a little more important.

But this will go down for posterity, so it's all good. Thanks.
_________________
The previous page has been superseded by the following page:

This page intentionally left blank.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Federation Commander Forum Index -> Miniatures All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group