Hydran Ranger & Lancer Mini Lengths?

schoon9953 · Post by **schoon9953** » Thu Dec 30, 2010 4:59 pm

Hi Folks,

I bought a set of Feds and Lyrans minis so I can measure the actual minis to support the creation of my LEGO ships (this thread), but I'm hankering to do some Hydrans.

Could the owner of these two minis get me the length of the figures, so I can use that to properly scale my next LEGO creations?

Thanks

Scoutdad · Post by **Scoutdad** » Fri Dec 31, 2010 4:18 am

Tried to measure accurately, but apparently the batteries in the digital calipers need replacing.
According to the machinists rule and some good ol' mark I eyeballing...

The Lancer measures 1 3/4" from nose to tail.
It's 7/32" wide at the nose, 5/16" wide at the tail, and the widest part of the body is 1/2" wide.
The thickness of the Lancer at the thickest point is 5/16".

The Ranger measures 2 3/4" from nost tothe tail end of the body... measurign to the rear end of the engines makes it 3" long.
It's 5/8" wide at the back of the forward section, the main body is 3/8" wide, and it's 1" from warp engine to warp engine.
The Ranger is also 3/16 inch thick... plus 3/16" for the upper warp engine.

schoon9953 · Post by **schoon9953** » Sat Jan 01, 2011 3:43 am

Thanks, Scoutdad.

I'll post the LCAD designs here after I get things designed.

Happy New Year!