I recently had a situation where my Fed Old CL was running from a Pl-S. When it impacted, I checked and realized the torp had actually died last impulse due to a combination of time and phaser damage. How should one handle the diminution of plasma warheads? Should one check at the end of each impulse (or maybe at the start?) to see if the torp is still viable? (I realize this is not so much a question as a request for advice)
Also, the rules (4J3b) say the the impulse of launch is not included in the calculation of a torp's duration of travel. If a torp is launched on impulse 1, and hits on impulse 3, which column of the strength table is consulted? 2 or 3? The table says "Impulse of Impact" but I'm uncertain whether that means "impulses after launch" or "total lifetime of torp."
Plasma torpedo question...
Moderators: mjwest, Albiegamer
1. You should probably check each impulse. I would recommend checking at the end of each impulse it fails to impact. If it will do no damage if it impacts next impulse, remove it from the board.
2. If a torp is launched on impulse 1, and hits on impulse 3, use column 2. I would argue that both terms are effectively the same, but by what looks to be your perspective, it is "impulses after launch".
2. If a torp is launched on impulse 1, and hits on impulse 3, use column 2. I would argue that both terms are effectively the same, but by what looks to be your perspective, it is "impulses after launch".
Federation Commander Answer Guy
I see - since plasmas are launched last thing in an impulse, that makes sense.
So...if ships A and B are in the same hex, and B launches a plasma at A, it does not impact immediately even though it is in the same hex as its target. It will impact on the first SubPulse of the following impulse, correct?
So...if ships A and B are in the same hex, and B launches a plasma at A, it does not impact immediately even though it is in the same hex as its target. It will impact on the first SubPulse of the following impulse, correct?
has just moved and is 1 hex away, you could move into its hex, exit the hex, and move 1 more hex before it could move again?Ok, I was not precise enough in my statements.
A seeking weapon can only impact during a movement sub-pulse. It is not necessary for either the target or seeking weapon to move that sub-pulse.
To directly answer your question, no. If a target enters the hex of a seeking weapon, or if a seeking weapon enters the hex of its target, or if neither move, but are in the same hex, the seeking weapon impacts.
In your example, the seeking weapon impacts the moment the ship enters the hex of the seeking weapon. However, you could completely move around it without getting hit.
The one special case is if enemy ships are in the same hex, one launches a seeking weapon at the other, and the target then moves speed 24+1. That allows it to move out of the hex before getting hit. In pretty much every other situation where a target and seeking weapon share a hex, the seeking weapon impacts.
A seeking weapon can only impact during a movement sub-pulse. It is not necessary for either the target or seeking weapon to move that sub-pulse.
To directly answer your question, no. If a target enters the hex of a seeking weapon, or if a seeking weapon enters the hex of its target, or if neither move, but are in the same hex, the seeking weapon impacts.
In your example, the seeking weapon impacts the moment the ship enters the hex of the seeking weapon. However, you could completely move around it without getting hit.
The one special case is if enemy ships are in the same hex, one launches a seeking weapon at the other, and the target then moves speed 24+1. That allows it to move out of the hex before getting hit. In pretty much every other situation where a target and seeking weapon share a hex, the seeking weapon impacts.
Federation Commander Answer Guy
Re: determination of plasma warhead strength...is this the correct way to calculate it?
1. At the time of impact, consult the table in 4J3b and determine what the strength of the warhead is based on its time on the board.
2. Subtract the damage done by phaser fire from the above number.
The alternative would be to keep a running tally each time the torp is damaged, but that would be a lot of record keeping, and I'm guessing the end result is the same, although I would have to work up a spreadsheet to be sure.
1. At the time of impact, consult the table in 4J3b and determine what the strength of the warhead is based on its time on the board.
2. Subtract the damage done by phaser fire from the above number.
The alternative would be to keep a running tally each time the torp is damaged, but that would be a lot of record keeping, and I'm guessing the end result is the same, although I would have to work up a spreadsheet to be sure.